Cable Testing Equipment

Merchanical Strength Cable Testing Equipment For Completed Flexible Cables

Merchanical Strength Cable Testing Equipment For Completed Flexible Cables

  • Model:

Flexible Cables Flexing Tester HDX1302

 

 

Test objectCompleted flexible cables
TestFlexing test
StandardIEC60245-1, IEC60245-2 figure 1
Current loading0-25A
Voltage loading0-400V
Testing speed0.33m/S
Testing distance1000mm
Suitable cores2-18
Nominal cross-sectional area0.2~4mm2
Diameter of pulleys3 piece, 60, 80, 120, 160, 200 for options
Combined weights0.5kg, 1kg, 1.5kg, 2kg, 2.5kg, 3kg, 3.5kg, 4kg, 6kg, 7.5kg, 8kg
Fault testingCurrent interruption, short circuit between conductors, test and short circuit between the pulley.
Power supply220VAC 50Hz

 

Description:

This device is used for checking mechanical strength of completed flexible cables. This test does not apply to flexible cables with cores of nominal cross-sectional area greater than 4mm2 and cables having more than 18 cores laid up in more than two concentric layers.

According to the standard IEC60245-1 Rubber insulated cables-Rated voltages up to and including 450/750 V-Part 1:General requirements, IEC60245-2 clause 3.1 Figure 1 Rubber insulated cables-Rated voltages up to and including 450/750 V-Part 2: Test methods.

 

Test sampleCompleted flexible cables.

 

FeatureThis cable tester consists of a carrier C (see IEC60245-2 Figure 1),a driving system for the carrier and four pulleys for each sample of cable to be tested. The carrier C supports two pulleys A and B, which are of the same diameter. The two fixed pulleys, at either end of the apparatus, may be of a different diameter from pulleys A and B, but all four pulleys shall be so arranged that the sample is horizontal between them. The carrier makes cycles (forward and backward movements) over a distance of 1 m at an approximately constant speed of 0,33m/s between each reversal of the direction of movement. A sample of flexible cable about 5 m long shall be stretched over the pulleys, each end being loaded with a weight. The mass of this weight and the diameter of pulleys A and B are given in following table.