Ingress Protection Test Equipment

IEC60529-2001 Ingress Protection Test Equipment / Fig 2 Sand And Dust Test Chamber For IPX5 and IPX6

IEC60529-2001 Ingress Protection Test Equipment / Fig 2 Sand And Dust Test Chamber For IPX5 and IPX6

  • Model:

IEC60529-2001 Sand And Dust Test Chamber For IPX5 and IPX6 Test

 

product introduation

 

The sand and dust test chamber is designed and manufactured according to IEC60529-2001 < Degrees of protection provided by enclosure (IP code)> Fig 2, IEC60598-1-2008 and etc. It artificially simulates the dust environment to test the dust-proof ability of the test samples.

The test device is suitable for electrical products’ sand and dust test of first characteristic numeral 5 and 6 (IPX5 and IPX6). It is used to test sealing parts and enclosure’s sand and dust resistance capacity of the electrical and electronic products, car and motorcycles spare parts and seals. In order to detect the use, storage, transport performance of the electrical and electronic products, car and motorcycles spare parts and seals under the sand and dust environment.

The chamber can provide a non-laminar flow of dust-loaded vertically circulating air, can be timed controlled; also be equipped with a vacuum pump which can vacuum the test sample, the exhaust volume and pressure can be adjusted; in addition, the inside chamber is configured with a airflow temperature control device, to ensure that the test is under standard environmental conditions.

The test equipment uses intelligent and humanized PLC control system, the inner of the test equipment is made of high quality SUS304 stainless steel, the enclosure is A3 plate electrostatic spraying. And it is also having large observation window and manual wiper device. The security protection is good.

 

Parameters:

 

ModelHH0810
Working size(mm)L1500*W800*H800
Outer size (mm)L1850*W1350*H1800
Main technical parametersTemperature rangeRoom temperature
Test dustdry talc which can go through the sieve of 75μm and the square sieve of wire diameter 50μm.
Test sand (or talc) dosage

2kg/m³

 

Vacuum pumpUltimate vacuum:2Pa
Air pressure meter0~-1.0Mpa
Sample rack height adjustment range

0~750MM

 

Timing range

 

0~99 hours 59 min

Timing accuracy

 

±1min

Load cycle control

 

0~99 hours 59 min

Ash blowing cycle control

 

1s~9999 min
Sand and dust concentration2~4kg/m3
Air flow speed≤2m/s

 

Device NameDust and Sand Test Chamber

 

Main configuration

CabinetEnclosure materialStainless steel
Inner materialSUS304B Stainless steel
Lead holeIt is for test sample’s power cord to be connected to the external power supply
Observation windowlarge observation window in the middle of the door
Electrical control systemController

PLC Control:

A. blowing dust time (stop, blowing) can be adjusted

B. Cycle: arbitrary adjustable

C. Preset test time: 0.1H-9999.9H arbitrary adjustable

D. Power: On-off- On

E. There are accumulating function and power-off protection function

 

Vacuum systemEquipped with a vacuum pump, pressure gauge, air filter, pressure regulator, connecting pipe

Security

Protection

Device

Power overload, short-circuit protection
Ground Protection
Voltage Protection
Motor phase loss protection
Alarm beep prompt

 

Picture for reference: