Switch Tester

Coupler Withdrawal Testing Apparatus Used To Ascertain The Maximum And Min. Force

Coupler Withdrawal Testing Apparatus Used To Ascertain The Maximum And Min. Force

  • Model:

Coupler Withdrawal Testing Apparatus Used To Ascertain The Maximum And Min. Force

 

 

Standard:Confirm to the IEC60320-1 clause 16 figure12 standard requirement.

 

Application:This device is mainly used to ascertain the maximum force necessary to withdraw the connector from the appliance inlet and the minimum force necessary to withdraw a single pin gauge from the appliance inlet, it can also for testing connectors for hot conditions and those for very hot conditions.

 

Test sample:Coupler.

 

Feature:This device consists of a control cabinet, mounting plate, heating device, instrument input socket (standard equip with 10A for testing connectors for hot conditions, 10A and 16A for very hot conditions) hook, and the principle weight,supplementary weight.

The appliance inlet is fixed to the mounting plate A of an apparatus as shown in figure 12, so that the axes of the appliance inlet pin are vertical and the free ends of the pins are downwards. For testing connectors for hot conditions and those for very hot conditions, a heating device C is provided, and on this the appliance inlet is mounted. The principle mass is hung on the connector without jolting and the supplementary mass is allowed to fall from a height of 5 cm on to the principal mass. The connector shall not remain in the appliance inlet. For testing connectors for hot conditions and for very hot conditions, the heating function should be turned on, start testing the maximum withdrawal force after achieving to the temperature.

.

Parameters:

1. Power supply:220V,50/60HZ.

2. Table 3-Maximum and minimum withdrawal forces

Type of connector

Withdrawal forces

N

Multi-pin gauge maximumSingle-pin minimum
0.2A, 2.5A,6A and 10A501.5
16A602

 

3. Maximum withdrawal forces

Maximum withdrawal forcesPrinciple weightSupplementary weight
50N45N(with hook)5N
60N45N(with hook)+4N+5N6N
Note: The weight hook are included in the weight of 45N.

 

4. Minimum withdrawal forces

Minimum withdrawal forcesWeight
1.5N

1.5N weight and 10Alive wire or ground wire of the

single-pin

2N

2N weight and16Alive wire or ground wire of the

single-pin

Note: The weight of the single-pin is included in the corresponding weight

 

5.The heating gauge of 10A for testing connectors for hot conditions, 10A and 16A for very hot conditions, others are test gauge in cold conditions, test gauges are optional.